亚洲中文字幕在线观看,九九热免费视频,好湿好紧视频,国产一区二区三区精品视频,一本一道av无码中文字幕

亚洲中文字幕在线观看,九九热免费视频,好湿好紧视频,国产一区二区三区精品视频,一本一道av无码中文字幕
  L-07型 L-08型 L-09型
  L-K100型
  L-07A型 L-250A型
  L-500型 L-500D型 L-1000型
  L-3000型 L-5000型 L-9000型
  L-200型
  L-07T4型 L-09T6型
 
 
產品展示
 
自動門故障檢查與排除
 

狀況一:門扇無法開啟或關閉 Door can't to open or close.

原因一:門扇上方與橫梁接觸
Cause 1:Above the door-leaf touches with the crossbeam.
原因二:門扇與地軌接觸
Cause 2:The door-leaf touched with the ground guide rail.
處理:調整門扇與橫梁間隙
How to solve:Adjustment the interval between the door-leaf height and crossbeam.
處理:調整門扇高度
How to solve:Adjustment door-leaf height.
原因三:門扇脫軌
Cause 3:Door-leaf derails the track.
原因四:門扇未垂直
Cause 4:Door-leaf does not vertical.
處理:重新強門扇置入軌道。
How to solve:Put the door-leaf into the track again.
處理:調整地軌位置 。
How to solve:Adjust the ground guide rail/wheel position.
原因五:感應器故障或未接線至集線器。
Cause 5:Sensor breakdown or doesn't contact to Combined Terminal Block.

處理:
1.若感應器故障則更換新的感應器。
2.檢查感應器是否連接至集線器。
How to solve:
1. If sensor breakdown please change a new one.
2. Check sensor whether connect to Combined Terminal Block.
狀況二:門扇運行不順暢 Door-leaf isn't smooth while the running of the operation.
原因一:吊輪按裝未垂直。
Cause 1:Hanging whell installs not vertical.
原因二:門扇與地軌有摩擦或地軌臟污。
Cause 2:Door-leaf rub against the ground rail or the ground rail dirty.
處理:重新調整吊輪。
How to solve:Readjust hanging wheel.
處理:
1.調整門扇高度。
2.清理地軌的臟污。
How to solve:
1. Adustment door-leaf height. 
2. Clean up the ground rail.
原因三:軌道未垂直。
Cause 3:Track is not vertical.

處理:重新調整軌道的垂直位置。 
How to solve:Readjust the vertical position of the track.
原因四:軌道未水平。
Cause 4:Track is not level.

處理:重新調整軌道的水平位置。
How to solve:Readjust the level position of the track.

狀況三 門扇運行有雜音 The door-leaf sends out abnormal noise while operating.

原因一:吊輪螺絲松動。
Cause 1:The screw of the hanging wheel become loose.

處理:重新將吊輪螺絲旋緊 。
How to solve:Refasten the screw of hanging wheel.
原因二:吊輪損壞。
Cause 2:Hanging wheel attrition .
原因三:吊輪臟污。
Cause 3:Hanging wheel dirty.
處理:更換吊輪。
How to solve:Replacing hanging wheel.
處理:清潔吊輪。
How to solve:Clean the hanging wheel.
原因四:軌道臟污
Cause 4Track is dirty.

處理:清潔軌道 。
How to solve:Clean the track.
 
問題 可能原因 檢查方向 排除操作
無開門
動作
1.無電源 電路斷路 檢查電路斷點
電源開關未開 開啟電源開關
2.門被鎖住 門鎖鎖住,控制器無動作 開啟門鎖
3.感應器故障 感應信號燈有動作 檢查控制器
感應信號燈無動作 檢查感應器線路或更換感應器
速度太慢 1.速度設置太慢 控制器速度調整 調整開門或關門速度
2.門扇遇到阻礙物,變成慢速 軌道施工不良或臟污 重新施工或清理軌道
3.門扇滑動阻力過大 關閉電源,用手使門滑動并檢查地面導軌是否有臟污 清理地面導軌
吊滑輪磨損 更換吊滑輪
檢查門扇底部的鎖閂是否松動 固定好鎖閂
檢查地面導輪是否已損壞或松動 更換或重新固定地面導輪
門扇
開不到底
處于半開模式 檢查全開/半開開關 切換至全開
門扇
不能關閉
1. 門扇處于全開狀態無法關閉 感應器信號燈持續亮著 感應器線路檢查或更換感應器
2. 門扇管到一半隨即開啟 感應器誤動作 調整或更換感應器
 
Problems Reasonable Check How to solve
The door-leaf can't opening. 1.No power. The broken circuit. Check the broken circuit.
Not turn on the power switch. Turn on the power.
2.The door be locked. Door is locked and no movement action. Untie the door lock.
3.The sensor is breakdown. Signal light is on. Check the Micro-Controller.
Signal light is off. Check the line or change the sensor.
Speed is too low. 1.The speed adjustment too slow. Readjust the speed regulate button. Readjust opening/dosing door speed.
2.There is hindrance in the track. The tarck is dirty or install bad. Reinstall or clean the track.
3.Door-leafs moves with the resistance. Check whether track dirty. Clean the track.
The hanging wheel set is abrasion. Change a new hanging wheel set.
Check the door lock bolt in the door bottom. Fix the lock bolt.
Check whether the ground wheel broken. Change a new ground wheel.
The door-leaf can't open completely. In the half-open way. Check full-open/half-open switch. Turn on full-open switch.
The door-leaf can't close down. 1. In the full-open way. The sensor keeps working. Check sensor or change a new sensor.
2. The door-leaf couldn't completely shot down then suddenly open again. The sensor couldn't be correct install or the sensor is bad. Adjust the sensor or change a new one.
 
   
 

汕頭市良治門控設備有限公司 版權所有 [中文版] 技術支持:華君云科技

粵ICP備14053078號 | 粵公網安備:44051102000657號

重型自動門、加重型自動門、超重型自動門、大型自動門、特大型自動門、重疊自動門、超重型重疊自動門、大型重疊自動型、特大型重疊自動門、弧形自動門、超重弧形自動門、大型圓弧門、特大型圓弧門、大型90度平開門、超重大型自動門定制、超重大型重疊門定制、超重大型弧形門定制、超重大型90度平開門定制、自動門、自動感應門、感應門電機、自動門電機